Table of Contents
Advertisement
Calibrate
To regularly automate the luminance
compensation, you may activate the
Calibration Reminder command under
LUMINANCE, so that when the usage
time of your monitor is up to 50 hours, you
will be ask to perform the calibration. See
Calibration Reminder on page
You can also launch Calibrate via Visual Optimizer and the Calibrate command under the LUMINANCE
on-screen menu.
With the sensor on the back of the handheld monitor
controller, Calibrate ensures you the accurate display
measurement.
• Press Calibrate to bring out the following
message.
• Place the sensor as the on-screen instructions
state.
38.
Put the attached suction cap on the upper panel of
the display to balance the weight of the controller.
The calibration takes around 10 to 15 seconds. When
done, the following message will display:
The Calibration Completed! message will be
displayed in English.
Adjusting your monitor
33
Advertisement
Table of Contents
