Jabra GN 8120 User Manual page 7

Add New Hardware Wizard - Human Interface Device (Windows 98 SE Instal-
lation)
1. Next, the Wizard automatically installs the USB Human Interface Device. The Add
New Hardware Wizard (5) indicates that it has found the USB Human Interface
Device. Click Next.
2. The Wizard prompts you to search for the best driver for your device or select the
driver you want from a displayed list (2). Select Search for the best driver for your
device. Click Next.
3. Windows now searches for new drivers in a specific location (3). Uncheck all the
boxes. Click Next.
4. The Wizard indicates that it is ready to install the best driver for this device (6).
Click Next to install the driver.
5. Click Finish when the Wizard is complete.
Add New Hardware Wizard - USB Audio Device (Windows 98 SE & Windows Me
Installation)
1. Next, the Wizard automatically installs the USB Audio Device. The Add New Hard-
ware Wizard (7) indicates that it has found the USB Audio Device. Click Next.
2. The Wizard prompts you to search for the best driver for your device or select the
driver you want from a list (2). Select Search for the best driver for your device.
Click Next.
3. Windows searches for new drivers in a specific location (3). Uncheck all the boxes.
Click Next.
4. The Wizard indicates that it is ready to install the best driver for this device (8).
Click Next to install the driver.
5. Click Finish when the Wizard is complete.
If the Wizard Cannot Locate the Driver
If the Add New Hardware Wizard cannot locate the driver, insert your Windows
Operating System CD-ROM into the CDROM drive. Once inserted, press Back, and check
the box for your CD-ROM drive (usually D). Click Next. Click Finish when the Wizard is
complete.
Note: Do not unplug the USB connector from the computer while an application that
uses USB audio is running. This could cause a system crash.
5. Adjusting the Speaker Volume, Side Tone and Micro-
phone Levels
• Test that the speaker volume in your headset is working and set at a comfortable
level by adjusting the blue volume rocker control referenced in the introduction dia
7