Filter Checking Device For The Detection Of Grease And Active Carbon; Led - Indicator For Grease Filter C; Led - Indicator For Active Carbon Filter D; Resetting The Saturation Indicator - AEG 2060 D Operating And Installation Manual

Hide thumbs Also See for 2060 D:

Table of Contents

Filter checking device for the detection of

grease and active carbon

This type of vapour hood is predisposed with a device that signals

when the grease or active carbon filter requires cleaning (sold with the

active carbon filter by the manufacturer specialized in ventilation

equipment).

This type of vapour hood is supplied by the manufacturer without the

active carbon filter, therefore the saturation signal is disabled.

The hood is purchased with active carbon filter included, and the

saturation signal is activated as follows:

Depress and hold the A and B buttons simultaneously for 3 seconds.

Initially only the LED indicator signal for the grease filter C is

activated, shortly after the LED indicator for the active carbon filter D

will activate, at this point the saturation detection has been enabled.

To switch off the saturation detection : depress and hold the A and B

buttons for 3 seconds until the LED indicator for the active carbon filter

is flashing.

Led – Indicator for grease filter C

The LED indicator for the grease filter will flash when it requires

cleaning.

Follow the maintenance instructions.

The LED indicator for the active carbon filter illuminates when the filter

requires replacing.

This occurs after about 160 working hours from when the active

carbon filter was first put into operation.

After cleaning the filter depress and hold the G and H buttons again

for 3 seconds until the LED – grease filter indicator or the LED – active

carbon indicator D are no longer flashing.

Table of Contents