Maintenance; Metal Grease Filter; Active Carbon Filter - AEG Electrolux DD8692-M Instruction Manual

Instructions for use

MAINTENANCE

Constant maintenance guarantees proper operation and longterm reliability. Particular
attention should be paid to the metal grease filters and, for recirculation hoods only, to
the activated charcoal filters. The appliance is equipped with a system that indicates
automatically when it is time to carry out maintenance operations.

Metal grease filter

• Cleaning
This filter must be washed when
LED V1 starts to flash, or at the
most once every 2 months, using
a normal household detergent; its
compact size also enables it to
be washed in a dishwasher.
• Replacement
Remove the filter, pushing the
handle towards the rear of the
hood. When replacing, ensure
that the handle faces outwards.
• Enabling the alarm signal
The hood is already set up to trigger an alarm indicating saturation of the metal grease
filters,so this function does not need to be enabled.
• Resetting the alarm signal
To turn the alarm signal off, proceed as follows:
- Turn off the Lights L and the Suction Motor V1;
- Press the Speed V3 for at least 3 seconds, until the Leds flash in confirmation. In any
case the saturated filters alarm will only come into operation when the suction motor is
turned on.
ATTENTION - There could be a possible fire hazard if the filters are not replaced
according to these instructions.

Active carbon filter

• Operation
The activated charcoal filter is only fitted in recirculation type hoods.It will retain odours
until it becomes saturated. It cannot be washed or regenerated, and must be replaced
when the Intensive Speed LED I starts to flash, or at least once every 4 months of
use. Attention: in recirculation type hoods the V1 Motor LED may start to flash as well as
the Speed + V3 LED. This indicates that as well as replacing the activated charcoal
filter, it is also necessary to perform maintenance operations on the metal grease filters
(see paragraph Metal grease Filter).
38