Maintenance - Ryobi CDR180 Owner's Operating Manual

To set the clock:
 Press the CLOCK button until the time is displayed on
the digital display.
 Press and hold the CLOCK button. The number
representing the hours will blink on and off.
 Press the VOLUME UP or VOLUME DOWN button to
set the hour.
NOTE: To set the clock to an hour between noon and
midnight, press the VOLUME UP or VOLUME DOWN
button until "PM" appears in the display.
 Press the CLOCK button. The number representing
the minutes will blink on and off.
 Press the VOLUME UP or VOLUME DOWN button to
set the minutes.
 Press the CLOCK button. The clock is now set.
NOTE: If AAA batteries are removed or lose charge for
more than 15 seconds, clock settings will be lost. Settings
are not affected by the removal of the 18 V battery.
USING MP3 AND CD PLAYERS (NOT INCLUDED)
See Figure 6.
 Select AUX mode.
 The retainer strap may be used to secure an MP3
player into position.
NOTE: The retainer strap cannot secure CD players.
 Connect the integrated auxiliary cable to the MP3 or
CD player.
NOTE: The auxiliary cable cannot be removed from the
radio.
 The CD or MP3 player must be ON and in PLAY mode
for sound to be heard through the speaker.
 All MP3 player controls can be used normally while
connected to the radio.
NOTE: Volume for any device connected through the
auxiliary connector can be adjusted using the volume
control for that device or with the VOLUME UP or
VOLUME DOWN buttons on the radio.
 Turning the radio OFF will NOT turn the MP3 player
OFF.
 The integrated auxiliary cable DOES NOT provide
charging function.
 For complete operating instructions for all MP3 and
CD players, always refer to the manual that was
included with your model.
English

MAINTENANCE

When servicing, use only identical Ryobi replacement
parts. Use of any other parts may create a hazard or
cause product damage.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
Do not at any time let brake fl uids, gasoline, petroleum
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury.
Do not abuse power tools. Abusive practices can
damage the tool as well as your workpiece.
Do not attempt to modify this tool or create accessories
not recommended for use with this tool. Any such
alteration or modifi cation is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
SYMBOL
Safety Alert
V Volts
Hertz
Hz
Alternating Current
W Watts
No-load speed
n
o
min -
1
Revolutions or reciprocations per minute
Double insulation
Recycle unwanted
5
WARNING
WARNING
WARNING
WARNING