Table of Contents
Advertisement
26
Technical data
Water drops have dries onto glasses and dishes • Increase rinse aid dosing.
If after all these checks, the problem persists, contact your local Service Force Centre.
Technical data
Dimension
Electrical connection - Voltage
- Overall power - Fuse
Water supply pressure
Capacity
Hints for test institutes
Testing in accordance with EN 60704 must be carried out with appliance fully loaded and
using the test programme (see "Washing programmes").
Test in accordance with EN 50242 must be carried out when the salt container and rinse
aid dispenser have been filled with salt and rinse aid respectively and using the test pro-
gramme (see "Washing programmes").
Amount of detergent required:
Rinse aid setting:
The wash results are not satisfactory
• The detergent may be the cause. Contact the
Width - height - depth (cm)
Information on the electrical connection is given on the rating
plate on the inner edge of the dishwasher's door
Minimum - Maximum (MPa)
Place settings
Full load: 12 standard place settings
5 g + 25 g (Type B)
position 4 (Type III)
detergent manufacturer's consumer care line.
59,6 x 81,8-89,8 x 57,5
0,05 - 0,8
12
Advertisement
Table of Contents
