Fitting The Vent Hose - AEG T30 User Information

125987091.qxp 2007-03-23 14:47 Page 9
Installation

Fitting the vent hose

To simplify the installation, there is a choice of vent outlets: one at the back,
the others in the left and right-hand side.
Connect the hose to whichever is the more convenient by pulling the ring nut
(A) from the vent outlet at the back, screwing it on to the hose and pushing it
firmly back into place.
The unused vents should now be sealed with the special snap covers provid-
ed.
Advice: If the hose is long and the room temperature low, the moisture might
condense to water inside the hose. This is an unavoidable natural phe-
nomenon. To prevent this water from Iying in the hose or flowing back into
the tumble dryer, it is advisable to drill a small hole (dia.
3 mm) in the lowest point of the hose and to place a small container below
it.(See picture, point B).
Once connected to the dryer, run the vent hose to the desired outlet point,
ensuring that the run's overall length is less than 2 m, and that it contains no
more than two bends. As to the outlet itself, if you have decided on a fixed
wall/window grille, a good local builder's merchant should be able to supply
you with the necessary fittings and installation advice.
9