Installation; Positioning - AEG T30 User Information

Aeg tumble dryer
Hide thumbs Also See for T30:
Table of Contents

Advertisement

125987091.qxp
2007-03-23
14:46
Page 8

Installation

Installation

Positioning

It is recommended that, for your convenience, the machine is positioned
close to your washing machine.
Whilst drying, the tumble dryer will expel a certain amount of warm, very
moist air, and this should be removed from the room as quickly as possible to
prevent condensation. In an extremely well ventilated room or close to an
open window, this may occur naturally.
However, in general, it is better to carry the dryer's exhaust outside via the
100 mm diameter flexible hose supplied with the appliance; ending either
temporarily at an open window, or permanently at a fixed ventilation grille, fit-
ted to an exterior wall or window.
The tumble dryer must be installed in a clean place, where dirt does not build
up.
Make sure there are no obstructing items or material near the air-intake lou-
vres provided at
the back (e.g. paper, rags etc.).
To keep vibration and noise to a minimum when the dryer is in use, it should
be placed on a firm, level surface.
Once in its permanent operating position,
check that the dryer is absolutely level with
the aid of a spirit level. If it is not, raise or
lower the feet until it is
The feet must never be removed.
Do not restrict the floor clearance through deep-pile carpets, strips of
wood or similar. This might cause heat build-up which would interfere
with the operation of the appliance.
Important
When operating the tumble dryer, the room temperature must not exceed
35°C, as it may affect the performance of the appliance.
8

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents