EPOX 6VBA-E Instructions Manual

A pentium ii or pentium iii slot1 processor based agp, supports pc-133 sdram module

Advertisement

6VBA-E
motherboard (100/66MHz)
TRADEMARK
All products and company names are trademarks or registered
trademarks of their respective holders.
These specifications are subjected to change without notice.
Manual Revision 4.2
May 25, 1999

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 6VBA-E and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for EPOX 6VBA-E

  • Page 1 6VBA-E motherboard (100/66MHz) TRADEMARK All products and company names are trademarks or registered trademarks of their respective holders. These specifications are subjected to change without notice. Manual Revision 4.2 May 25, 1999...
  • Page 2 Features 6VBA-E 6VBA-E Features: • 6VBA-E is based on the Pentium® II/III Processor operating at 266 ~ 550MHz on Slot1. The board is configured by an ESSJ (Easy-Setting- Single-Jumper) to match your CPU clock speed. • Designed with VIA Apollo Pro PCIset.
  • Page 3 6VBA-E Features • Supports the (4) Universal Serial Bus (USB) Ports. The onboard VT82C686A chip provides the means for connecting PC peripherals such as; keyboards, joysticks, telephones, and modems. • Built-in ATX 20-pin power supply connector. • ® Software power-down when using Windows 95/98.
  • Page 4 6VBA-E Installation 6VBA-E Detailed Layout Figure 1 Page 4...
  • Page 5: Device Connectors

    6VBA-E Installation The following must be completed before powering on your new system: Configure DIP Switch and Jumper to match your hardware System memory Configuration Device Connectors We design this motherboard with a DIP Switch to make your install fast and easy.
  • Page 6 6VBA-E Installation The 6VBA-E supports (3) 168-pin DIMMs (Dual In-line Memory Module). The DIMMs can be either EDO (Enhanced Data Out) or SDRAM (Synchronized DRAM). • DIMM SDRAM may be 83MHz (12ns), 100MHz (10ns) or 125MHz (8ns) bus speed. •...
  • Page 7 6VBA-E Installation Please install the motherboard into the chassis. Now that your motherboard is installed you are ready to connect all your connections (figure 10). Joystick/Midi port parallel port PS/2 Mouse USB port PS/2 KEYBOARD COM1 COM2 Speaker Line_in Figure 10 Chassis Panel Connector •...
  • Page 8 6VBA-E Installation (This is connected to the power button on the case. Using the Soft-Off by Pwr-BTTN feature, you can choose either Instant Off (turns system off immediately), or 4 sec delay (you need to hold the button down for 4 seconds before the system turns off).

Table of Contents