FBII OMNI-408EU User Manual page 19

Quick Forced On
If programmed by your installer, Quick Forced On allows you to turn
the burglar portion of your alarm system on to the Away mode,
bypassing all zones that are not ready. To enable Quick Force On:
Press [#], [2].
A valid User Code is still required to turn the system off.
The Quick Forced On feature is disabled on UL installations.
U L
Quick Exit
If enabled, this feature allows the user to exit without having to
disarm, then arm the system. It is activated by pressing the [STAY]
key while the system is armed and not in entry delay. This starts the
exit time, causes the keypad to beep once, and allows the user to exit
without disarming the system. The system returns to its last armed
state after the exit time has expired.
Quick Bypass
If you have Quick Bypass programmed for your system, you do not
have to use your User Code to bypass zones. The Quick Bypass
procedure is:
BYPASS
Bypassed zones are not protected when the system is turned on. After
the Bypass command has been accepted, the keypad sounds one long
beep, and the zone or zones bypassed slowly blink.
Keypad Functions (cont'd)
Yes
Yes
Yes
, Zone No. (1-8)
No
No
No
– 19 –