Operation Instructions - A.O. Smith Jaguar CEWHR User Manual

Operation Instructions

Please check whether the water heater is filled with water and whether the power plug is plugged in place
before using the water heater.
1 On/Off
Press the "On/Off" button to enter the "On" status as shown in Fig. 1. Press the button again to enter
the "Off" mode.
System Default Setting: The default temperature setting is 70 C.
TEMPERATURE
ACTUAL
CLOCK OFF-PEAK
TIMING ON
CLOCK
2 Temperature Setting
In the working status of the controller, press "" or "" button, the "Temperature Setting" and the
current set temperature will flash in the temperature window. The set temperature increases/decreases
0
by 1 C for each time the "" or "" button is pressed. If the button is pressed without pause, the
setting temperature increases/decreases continuously. If the button is released, it will exit the
temperature setting mode after the flashing stops.
In the working mode of the controller, the screen will display the actual water temperature and setting
temperature first (as shown in Fig. 2). Ten seconds later, it will display the characters "Clock" and the
time (as shown above in Fig. 3) both displays will alternate after 10 seconds.
Caution: Hot water exceeding 50 C can produce scalding injury. Particular care should be taken when
the temperature is set over 50 C for the safety of your family, especially children.
3 Clock Setting and View
(1) Clock Setting: First press the "Clock Setting" button for 3 seconds to enter clock setting mode
(as shown in Fig. 4). The hour field will flash first. Set the numbers by pressing "" or ""
button. The set hour will increase/decrease by 1 for each time the "" or "" button is
pressed. During flashing period, press the clock button again to enter clock "Minute" setting
mode, the minutes display will flash. Set the numbers through "" or "" button. If the
button is pressed without pause, the numbers will increase/decrease continuously. The hour
number setting range is between 0-23 and the minute number setting range is between 0-59.
TEMPERATURE SETTING
1000W
1500W
2500W
TIMING OFF
Fig. 1
SETTING
Fig. 3
0
0
0
ACTUAL TEMPERATURE
8
TEMPERATURE SETTING
Fig. 2