Important Installation And Utility Information - European Touch FORTE SPA Owner's Manual

I
MPORTANT
Electrical Service:
110V: A 110V, 60 Hz, 15 Amp GFCI protected grounded circuit must be used to supply power to the
pedicure spa. (220V if ordered in 220V configuration)
220V: A 220-240VAC, 50Hz, 7.5 Amp GFCI protected grounded circuit must be used to supply power
to the pedicure spa per local code.
Water Supply:
All plumbing connections must conform to local codes.
Normal water pressure of 30 to 80 PSI is required to correctly fill the basin to the proper level.
The hot water supply temperature must not exceed 120°F (49° C). Adjust your hot water heater accordingly.
For hot and cold water supply fittings and power drain fittings location, see figure 1 below.
Carefully connect the incoming water supply lines to the appropriate fittings located on the back of the pedicure
spa. Shut-off valves are recommended.
Backflow Protection Devices for Faucets with Side Spray: Check valves comply with ANSI/ASME
A112.18.3M, A112.18.1M, and CSA B125
ANSI/ASME A112.18.3M (Performance Requirements for Backflow Protection Devices and Systems in
Plumbing Fixture Fittings) is applicable to plumbing fixture fittings with outlets not protected by an air gap.
Included in the possible range of applications are fittings with hose connected outlets, fittings with pullout
spout, hand held showers, shampoo fittings and deck-mounted fittings. ASME A112.18.3M is now referenced
in ASME A112.18.1M (Plumbing Fixture Fittings) and CSA B125. Check valves are listed to both standards
with the Canadian Standards Association, IAPMO and UL.
ANSI - American National Standards Institute
ASME - American Society of Mechanical Engineers
CSA - Canadian Standards Association
IAPMO - International Association of Plumbing and Mechanical Officials
UL - Underwriters Laboratory
The pedicure spa drain must meet local plumbing codes. Check valve for drain (not provided) must be
installed by a licensed plumber.
Pedicure spa must be securely fastened to the floor as shown in figure 2 below. Fasten the pedicure spa to
the floor with at least two fasteners, one in the middle plastic support and one in the rear plastic support.
Back of Pedicure Spa
Figure 1
Document ID: 40080001
I
NSTALLATION AND
Rev: F Technical Support: 800-626-6912
U I
TILITY NFORMATION
Install Fasteners Here
Figure 2
Page 11 of 24