Candy TRIO 501-1 UK Instruction And Use page 20

Regulating the water softener with electronic programmer
The water softener can treat water with a hardness level of up to 60°Fh (French grading) or
33°Dh (German grading) through 5 settings.
The settings are listed in the panel below:
Level
4
The softener unit is set in the factory at level 3 (indicator light N.3) as this is suitable for the
majority of users.
Regulate the setting of your water softener unit according to the degree of hardness of your
water as follows: Open the door, press On / Off button, within 2 minutes press and keep
pressed for at least 10 seconds the Programme Selection button; the first three LEDs on the
left turn on for 3 seconds.
The LED associated with the set water softener starts flashing; successive button pushing will
set the water hardness levels (see table).
P1 P2 P3
N°1 N°2 N°3
LED
S
Information for the test laboratories
General programme comparison
Ref. EN 50242 standards:
1) Normal load
2) Shine setting: "4"
3) Amount of detergent: 18gr. for wash
20
Water
hardness
°fH
(French)
8 -
0 0
-
1 20
-
2 21 30
3 40
31
-
41 60
PR.
P4
P5
N°4
PROGRAMME SELECTION BUTTON
Water
hardness
Use of
regenerating
°dH
salt
(German)
no
yes
yes
yes
yes
P1
Water
softener
setting
indicator light N.1
indicator light N.1
indicator light N.2
indicator light N.3
indicator light N.4
P2 P3 P4 P5