Maintenance; Troubleshooting - GMC LS LINE/REDEYE Instruction Manual

5. Switch ON the laser line
generator.
6. Adjust the rotating dial
(2) to achieve desired line
projection.

Troubleshooting

Problem
Faint laser line projection
Laser line is not projected
Laser line angle appears not to line
up with a reference point

Maintenance

1. The laser line generator must be handled with care.
2. Avoid shock, vibrations and extreme heat.
3. Always store the tool indoor, switch to OFF position and
put it in its protective case.
4. Avoid dust and liquid into the tool, use damp cloth and
mild soap to clean the tool.
5. Keep the laser line generator dry and clean.
6. Check the batteries regularly to avoid deterioration.
7. No special maintenance operation is required to be
carried except the change of batteries as per description
given in this manual.
Note:
only be repaired by a qualified Service Technician with
laser experience.
Possible cause
Weak batteries
Bright lighted room
Switch is not ON
Batteries are flat
The rotating dial has not been
positioned correctly
Mounting surface is not on a
flat plane
9
This tool is not to be tampered with and should
Solution
Replace batteries
Use the laser enhancing glasses
Check that the switch has been
pushed down
Replace batteries
Adjust the rotating dial to the
correct position
Check the vials. Use the leveling
base and level the unit with the
adjusting knobs