Cleaning The Drum; Clean Operating Screen And Housing; What To Do If; Troubleshooting By Yourself - Electrolux EDC 5366 User Information

Cleaning the drum

1
Caution! Do not use abrasives or steel wool to
clean the drum.
3
Lime in the water or cleaning agents may form
a barely visible lining on the inside of the drum.
The degree to which the laundry has been
dried is then no longer detected reliably. The
laundry is damper than expected when re-
moved from the dryer.
Use a standard domestic cleaner (e.g. vinegar-based
cleaner) to wipe down the inside of the drum and
drum ribs.

What to do if...?

Troubleshooting by your-
self
If, during operation, the dryer shows an error display
(one or more displays flashing on the programme
progress display), check first of all whether you can
remedy the problem yourself by means of the table
below. If you cannot solve the problem: Switch the
machine off and on again. Reset programme. Press
the START/PAUSE button.
Problem
Dryer does not work.
Drying results unsatisfactory.
Possible cause
Mains plug is not plugged in or fuse
is not working correctly.
Loading door is open.
Have you pressed the START/
PAUSE button?
Wrong programme selected.
Lint filter clogged.
Heat exchanger clogged with lint.
Incorrect volume of laundry.
Ventilation slots in base area cov-
ered up.
Residue on inside surface of drum or
drum ribs.
Conductance of water at installation
site differs from standard setting of
machine.
Clean operating screen and
housing
1
Caution! Do not use furniture cleaners or ag-
gressive cleaning agents to clean the ma-
chine.
Use a damp cloth to wipe down the operating screen
and housing.
If the error display is still shown, please contact our
after-sales service and inform them which displays
are flashing.
Plug in at mains socket. Check fuse in
fuse box (domestic installation).
Close loading door.
Press the START/PAUSE button again.
Select a different programme the next
time you dry
(see "Overview of programmes" sec-
tion).
Clean lint filter.
Clean heat exchanger.
Observe recommended loading vol-
umes.
Uncover ventilation slots in base area.
Clean inside surface of drum and drum
ribs.
Re-programme standard setting for de-
gree of drying (see 'Programming op-
tions' section).
Remedy
17