Crankcase Components; Install Flywheel End Oil Seal; Install Lifter Feed Chamber Gasket And Cover - Kohler ECV940 Service Manual

Crankcase Components

M
O
L
K
J
A Camshaft
C Regulating Pin*
E Cross Shaft*
G Lifter Feed Cover
I Crankshaft
K Connecting Rod
M Piston Pin Retainer
O Piston Ring Set
*Mechanical Governor only.
62 690 05 Rev. --
A
B
D
I
C
N
E
G
F
P
B Locking Tab*
D Governor Gear*
F Lifter Feed Cover
Gasket
H Governor Yoke*
J Connecting Rod
End Cap
L Piston Pin
N Piston
P Oil Seal
NOTE: Make sure engine is assembled using all
specifi ed torque values, torque sequences, and
clearances. Failure to observe specifi cations
could cause severe engine wear or damage.
Always use new gaskets. Apply a small amount
of oil to threads of critical fasteners before
assembly, unless a sealant or Loctite
specifi ed or preapplied.
Make sure all traces of any cleaner are removed before
engine is assembled and placed into operation. Even
small amounts of these cleaners can quickly break down
lubricating properties of engine oil.
Check oil pan, crankcase, cylinder heads, and valve
covers to be certain all old gasket material has been
removed. Use gasket remover, lacquer thinner, or paint
remover to remove any remaining traces. Clean surfaces
with isopropyl alcohol, acetone, lacquer thinner, or
electrical contact cleaner.

Install Flywheel End Oil Seal

1. Make sure seal bore of crankcase is clean and free
of any nicks or burrs.
2. Apply a light coat of clean engine oil to outside
H
diameter of oil seal.
3. Install oil seal into crankcase using a seal driver.
Make sure oil seal is installed straight and true in
bore and tool bottoms against crankcase.

Install Lifter Feed Chamber Gasket and Cover

1. Install lifter feed chamber gasket, followed by lifter
feed cover over lifter feed chamber.
2. Install screws. Make sure all parts are properly
aligned. Torque screws to 6.6 N·m (58 in. lb.).
KohlerEngines.com
Reassembly
is
®
83