Adjusting The Rear Brake Light Switch - Yamaha YBR125ED Owner's Manual

1. Brake pedal free play adjusting nut
WARNING
G After adjusting the drive chain
slack or removing and installing
the rear wheel, always check the
brake pedal free play.
G
If proper adjustment cannot be
obtained as described, have a
Yamaha dealer make this ad-
justment.
G After adjusting the brake pedal
free play, check the operation of
the brake light.
PERIODIC MAINTENANCE AND MINOR REPAIR
Adjusting the rear brake light
switch
EWA10680
1. Rear brake light switch
2. Rear brake light switch adjusting nut
The rear brake light switch, which is ac-
tivated by the brake pedal, is properly
adjusted when the brake light comes
on just before braking takes effect. If
necessary, adjust the brake light switch
as follows.
1. Remove panel A. (See page 6-5.)
2. Turn the adjusting nut while hold-
ing the rear brake light switch in
place. To make the brake light
come on earlier, turn the adjusting
nut in direction (a). To make the
brake light come on later, turn the
adjusting nut in direction (b).
EAU22291 3. Install the panel.
6-19
6