Table of Contents
Advertisement
Use
Control panel
1 Detergent dispenser drawer and
programme chart
Programme Option buttons
Depending on the programme, different functions
can be combined. These must be selected after
choosing the desired programme and before
depressing the "Start/Pause" button.
When these buttons are pressed, the corresponding
pilot lights come on. When they are pressed again,
the pilot lights go out.
If an incorrect option is selected, the pilot lights flash
for about 2 seconds.
2 "Prewash / Super Rinse" button
Select "Prewash" option if you wish your laundry to
●
be prewashed before the main wash (not
available for wool and hand wash). The relevant
light illuminates.
The prewash ends with a short spin in programmes
for cotton and synthetic fabrics, whereas in the
programme for delicate fabrics the water is only
drained.
The "Super Rinse" option can be selected with all
●
programmes except the wool/handwash
programme. The machine will perform 2 additional
rinses. This option is recommended for people who
are allergic to detergents, and in areas where the
water is very soft.
Note: This two options cannot be selected together.
3 "Quick Wash" button
This button allows you to select the Quick Wash
function, for laundry that is only slightly soiled (not
for wool, hand wash and economy programme 2
"Cottons economy").
The washing time will be reduced according to the
type of fabric and the selected
programme/temperature.
Max. load for cotton 1,5 kg.
4 "Half Load" button
Select this button to reduce water consumption on
the rinse phase when washing a smaller load of
cottons or linens (maximum load size = 1,75 kg).
The machine will perform 2 rinses instead of 3.
This function can be used also for synthetics,
handwash, wool and delicate programmes, in
case of reduced load of laundry (less then the
maximum load size).
5 "Start /Pause" button
After having selected the programme and the
required options press this button to start the
machine. The corresponding pilot light stops flashing
and remains lit.
To interrupt a programme which is running, depress
the "Start/Pause" button: the corresponding pilot light
starts to flash.
To restart the programme from the point at which it was
interrupted, press the "Start/Pause" button again.
10
FO
Advertisement
Table of Contents
