WatchGuard® SSL 560 Quick Start Guide WatchGuard® Technologies, Inc.
Page 2
• F ind the serial number on your device and record it. • G o to http://www.watchguard.com/activate • L og in. NOTE: If you are new to WatchGuard, follow the instructions to create a profile. • F ollow the instructions on the screen. • I t is a good idea to download and extract your WatchGuard SSL feature key during activation. Extract the feature key on to the computer you will use to configure your WatchGuard SSL 560. Connect your WatchGuard SSL 560 • M ake sure your computer is configured with a static IP address on the 192.168.111.0/24 network. NOTE: The default IP address on the WatchGuard SSL 560 is 192.168.111.1. • C onnect the Ethernet interface on your computer to the interface (Eth1) on your WatchGuard SSL device. Eth 1 • ...
Page 3
Next Steps Congratulations! You have finished basic network setup of your WatchGuard SSL 560. You can now put the WatchGuard SSL 560 in your network and use the WatchGuard SSL Web UI to continue configuration, management, and monitoring tasks. If you configured your WatchGuard If you configured your WatchGuard SSL in Single Interface mode… SSL in Dual Interface mode… • W hen you put the WatchGuard SSL • W hen you put the WatchGuard SSL in your network, make sure you in your network, make sure you connect to Eth0. Eth1 is available connect both Eth0 and Eth1. only during the Quick Setup Wizard. • ...