Page 2
WatchGuard SSL 500 and SSL 1000 Setup WatchGuard SSL 500 and SSL 1000 Setup Register your WatchGuard SSL User Pack with LiveSecurity® Service Find the license that came with your WatchGuard SSL User Pack. Go to http://www.watchguard.com/activate. Log in. If you are new to WatchGuard, follow the instructions to create a profile.
Page 3
Hard disk drive with at least 300 MB of free space Select a dedicated computer on which to install the WatchGuard Administrator services. If you turn this computer off, the services do not run and no connections to the WatchGuard SSL device can be made.
Page 4
Services applet to manually start the WatchGuard Policy Service. Verify your services are installed in WatchGuard Administrator From WatchGuard Administrator, go to Monitor System > System Status. An error message appears for any system component that is not running. At this point in the setup process, you see an error that the Access Point is not running.
Page 5
Configure your WatchGuard SSL Access Point Connect Eth1 on your WatchGuard SSL Access Point device to the ethernet interface of a computer configured with an IP address on the 192.168.111.0/24 network. The default IP address of Eth1 on the WatchGuard SSL device is 192.168.111.1.
Need help?
Do you have a question about the SSL 1000 and is the answer not in the manual?
Questions and answers