AEG S93880KMB0 User Manual page 18

18
What to do if...
Problem
upper or lower square
is shown in the tempera-
ture display.
The compressor runs con-
tinuously.
Water flows inside the re-
frigerator.
Water flows on the
ground.
The temperature in the
appliance is too cold.
The temperature in the
appliance is too warm.
The temperature in the re-
frigeration is too warm.
The appliance does not
operate.
Possible cause
An error has occurred in meas-
uring the temperature
The Temperature regulator may
be set incorrectly.
The door is not closed correctly.
The door has been opened too
frequently.
The food temperature is too
high.
The room temperature is too
high.
The water outlet is clogged.
Food prevent that water flows
into the water collector.
The melting water outlet does
not flow in the evaporative tray
above the compressor.
The Temperature regulator may
be set incorrectly.
The Temperature regulator may
be set incorrectly.
The door is not closed correctly.
The food temperature is too
warm.
There is no cold air circulation in
the appliance.
Large quantities of food to be
cooled were put in at the same
time.
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
Solution
Call your service representative
(the cooling system will continue
to keep food products cold, but
temperature adjustment will not
be possible)
Set a warmer temperature.
Refer to "Closing the door".
Do not keep the door open longer
than necessary.
Let the food temperature de-
crease to room temperature be-
fore storage.
Decrease the room temperature.
Clean the water outlet.
Make sure that food do not touch
the rear plate.
Attach the melting water outlet
to the evaporative tray.
Set a warmer temperature.
Set a colder temperature.
Refer to "Closing the door".
Let the food temperature de-
crease to room temperature be-
fore storage.
Make sure that there is cold air
circulation in the appliance.
Insert smaller quantities of food
to be cooled at the same time.
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.