First Use - AEG S93880KMB0 User Manual

Selecting and dispensing water
Before dispensing water, select either carbonated water (2) or plain water (3). The actual
choice is indicated by the lit button.
Water selection can be changed while the water is running.
Water is dispensed by pressing a glass or other container towards the flap (6). Draw back
the glass or container to stop the water flow.
Any water that drips or is spilled is collected in the drip tray below the water dispenser. The
drip tray can be detached and emptied when necessary.
Lighting
The water dispenser lighting (7) illuminates automatically when water is dispensed.
For continuous lighting
1. Make sure that the water dispenser is unlocked.
2. Press the plain water button (3) until the lighting goes on (about three seconds).
Brightness is now about 50% until the dispenser is used.
Switch off the lighting
1. Make sure that the water dispenser is unlocked.
2. Press the plain water button (3) until the lighting goes out (about three seconds).
Water filter indicator
When the water filter indicator (4) lights up the water filter has about 20% remaining life-
time. In this situation, it is recommended that you buy a replacement filter.
When the water filter indicator starts flashing, the water filter lifetime is consumed .
Replace the water filter without delay, refer to "Installation of the water filter".
When the water filter is replaced. Press the plain water button (3) for a few seconds to reset
the water filter indicator.

FIRST USE

Cleaning the interior
Before using the appliance for the first time, wash the interior and all internal accessories
with lukewarm water and some neutral soap so as to remove the typical smell of a brand-
new product, then dry thoroughly.
Do not use detergents or abrasive powders, as these will damage the finish.
11
First use