Scorpio SR-i500 Installation Manual And User's Manual page 14

Ignition Disable / Anti-hijack Module (RID-5)
Installation
1. Cut the Ignition / Engine control wire (refer to options below)
2. Attempt to start bike to test if correct wire is selected. If bike starts the wrong wire is selected.
(contact Aritronix for assistance) If bike does not start, correct wire was selected continue to
step 3.
3. When Packaged the RID-5 wire ends have been treated with clear silicon to protect the
ends from fraying. Make sure they are stripped bare of this before continuing.
4. Connect one end of cut wire to one of the blue tap wires in RID-5 with provided butt
connector or any other solid connection options.
5. Connect second end of cut wire to second blue tab wire in RID-5 with provided butt
connector or any other solid connection options.
6. Test connections to insure that they are as solid as possible. *
7. Plug the RID-5 connector into the matching connector on Main Control Module (MCM)
Accessory Harness.
8. Test RID-5 by activating alarm (without perimeter sensor) and try to turn on bike. If bike turns
on, please contact Aritronix for assistance.
* Failure to test for a loose wire could cause an accidental engine cut off.
The Ignition / Engine control wire Options:
Option #1: Positive lead wire on fuel pump
Option #2: Positive lead wire on fuel injection system
Option #3: Positive wire that goes to the ignition fuse in fuse box. This should be
either a 10 or 15 amp fuse labeled IGN or START. (Carbureted Bikes)
Option #4: Ground wire from ignition module
Option #5: Positive wire from ignition module to ignition coil
Option #6: Wire connected between the ignition module and engine stop button
Operating the Anti-Hijack feature
While the engine is running, press and hold the transceivers' button #1 and button #2 at the same
time for 5 seconds. The siren will begin to chirp confirming that the Anti-Hijack feature has been
activated. 15 seconds later, the siren will go off continuously, and the engine will shut down. To
disarm, turn off the ignition switch and press button #2.
To Accessory Harness on
Main Control Module (MCM)
To CUT wire on Motorcycle
13