Becker TRAFFIC ASSIST Operating Instructions Manual page 71

To select a POI as a stopover:
> Press the desired POI.
It is set as the stopover and the Traffic
Assist starts route calculation to the
stopover.
To set a POI category:
You can set which categories the Traffic
Assist should take into account when
displaying the POIs.
> Press the POI button.
The current settings are displayed.
> Press one of the categories set, e.g.
Petrol station.
The complete category list appears.
> If necessary, scroll in the list and press
one of the categories which you would
like to set as a new category, e.g.
.
way station
The current setting is displayed again, the
category has now been
Petrol Station
replaced by the
Railway station
> Proceed in the same manner for the
other two categories as necessary.
> Finally, press
.
OK
An updated display appears of the POIs
available along the route, which takes into
account the change in categories.
NAVIGATIONAL MODE
Move map (toolbar)
In move mode, you can shift the map in
any direction required. You can do this by
Rail-
"pinning down" the map at any point and
then shifting it. With the toolbar activat-
ed, press any point on the map and move
category. it in the required direction.
The map is then moved accordingly after
a short delay.
Note:
If you wait too long before moving the
point, the position information regarding
the selected point appears on the map,
See "Playback of MP3 files during an ac-
tive navigation" on page 73.
>>>
> D
> GB
> F
> I
> E
> P
> NL
> DK
> S
> N
> FIN
> TR
> GR
> PL
> CZ
> H
> SK
71