Wash Cycle Completed/Removing Washing - AEG LAVAMAT W 1039 EXCLUSIV User Information

Wash Cycle Completed/Removing Washing

A wash programme normally ends with the final spin.
If SOAKING (EINWEICHEN) has been selected:
0 Release the SOAKING (EINWEICHEN) button. Main wash for COTTONS/
LINEN (KOCHWÄSCHE/BUNTWÄSCHE) or EASY-CARES (PFLEGELEICHT)
will run.
If RINSE HOLD (SPÜLSTOPP) has been selected:
The water must first be pumped out or the washing must still be spun.
0 Either turn the spin speed selector dial to the required speed
(water is pumped out and the washing spun according to the pro-
gramme that has been run; the spin speed can still be changed even
during the spin),
or
turn the programme knob clockwise to PUMP OUT (PUMPEN)
(water is pumped out without spinning),
or
turn the programme knob clockwise to SPIN (SCHLEUDERN)
(the water is pumped out and the washing spun at the set speed; the
spin speed can still be changed even during the spin).
Once the programme is completed:
For safety reasons, the door remains locked for 1-2 minutes after the
3
end of the programme.
1. Open the door.
2. Remove the washing.
3. Press the ON/OFF (EIN/AUS) button. The power indicator light will go
out. The washing machine is switched off.
4. Close the water valve.
5. Pull the washing powder drawer out slightly to allow it to dry. Leave
the door just slightly ajar so that the washing machine can air.
Important! If the washing machine is not used for a long time:
Close the water tap and disconnect the washing machine from the
electricity mains.
Operating Instructions
25