AEG LAVAMAT W 1039 EXCLUSIV User Information page 32

Operating Instructions
Problem
The washing machine
vibrates during opera-
tion or wobbles.
Water runs out under
the washing machine.
The washing machine
does not spin; there is
water in the drum.
32
Possible Cause
The transport packaging has
not been removed.
The height-adjustable screw
feet are not correctly set.
There is very little washing in
the drum (e.g. only one
dressing gown).
The water could not be com-
pletely pumped out before
spinning because
the drain hose is bent or
the drain pump is blocked.
The screw connection on the
inlet hose is leaky.
The drain hose leaks.
The drain pump cover is not
correctly closed.
Washing is stuck in the door.
Emergency drain hose is not
correctly sealed or is leaking.
RINSE HOLD (SPÜLSTOPP)
has been selected.
Soaking programme has fin-
ished.
Remedy
Remove transport packaging
according to the installation
and connection instructions.
Adjust the feet according to
the instructions for installa-
tion and connection.
This does not impair the
function.
Check along the drain hose
and remove any kinks
present, or clean the drain
pump and, if necessary, re-
move foreign bodies from
the pump housing.
Tighten the inlet hose screw
connection.
Check the drain hose and re-
place it if necessary.
Close cover correctly.
Interrupt the programme
and remove washing from
the door. Start the pro-
gramme again.
Seal the emergency drain
hose correctly (see section
"Carrying out an Emergency
Emptying Operation"). If the
emergency drain hose leaks
contact customer service.
Cancel RINSE HOLD
(SPÜLSTOPP).
Release SOAKING
(EINWEICHEN) button
(main wash programme will
follow).