Replacing The Lamp; Closing The Door - AEG SANTO 75448 KGR User Manual

18
What to do if...
Problem
Water flows on the
ground.
The temperature in the
appliance is too low.
The temperature in the
appliance is too high.
The temperature in the
refrigerator is too high.
The temperature in the
freezer is too high.
There is too much frost.
Technical problems

Replacing the lamp

CAUTION!
Disconnect the plug from the mains socket.
1. Press on the rear hook of the lamp cover by
a screwdriver and at the same time pull and
rotate the cover in the direction of the arrow.
2. Replace the lamp with one of the same pow-
er and specifically designed for household ap-
pliances. (the maximum power is shown on
the light bulb cover).
3. Install the lamp cover by fixing it into its orig-
inal position.
4. Connect the plug to the mains socket.
5. Open the door. Make sure that the light comes on.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
Possible cause
The melting water outlet does
not flow in the evaporative tray
above the compressor.
The temperature regulator is
not set correctly.
The temperature regulator is
not set correctly.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too
high.
Many products are stored at
the same time.
There is no cold air circulation
in the appliance.
Products are too near to each
other.
Food is not wrapped correctly.
The door is not closed correctly. Refer to "Closing the door".
The temperature regulator is
not set correctly.
electrical malfunction
Solution
Attach the melting water outlet
to the evaporative tray.
Set a higher temperature.
Set a lower temperature.
Let the product temperature de-
crease to room temperature be-
fore storage.
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.
Store products so that there is
cold air circulation.
Wrap the food correctly.
Set a higher temperature.
Contact Customer Service De-
partment
1
2