Troubleshooting - Electrolux EWT121 User Manual

TROUBLESHOOTING

Before call for servicing if you notice the problem as guidance on the table
below. It will be helpful your solution with some temporary symptom. You
washing machine will comeback to work as normal before service people
coming or waiting any queueing from service provider.
For some problems you will get a message in the display screen accompanied by
'Beeps'.
The message will be brief information about the problem and what you can do to
try and rectify it.
Problem
Machine not working
Machine has washed
load but will not spin.
Water in washbowl.
Will not fill with water
Water flowing into
washbowl indefinitely
Machine goes out of
balance or vibrates
excessively when
spinning
Water on floor
Display Code Possible Causes
Power not switched on
No electricity supply
through the power point
Machine not switched on
Water taps not turned on
Out of balance switch off
LD
Lid not fully closed
Out of balance
LD
Lid not fully closed
E20
Drain hose blocked
Too much suds causing
EF0
motor temperature
overload
Water taps not turned on
Inlet hoses blocked
Drain hose too low
Machine not level
Levelling feet not adjusted
Clothes not evenly
distributed
Too much water for load
size
Loose inlet hose
connections
Incorrect water level for
size of load
27
What to do
Switch on power point
Check power point with
another appliance
Press On-Off switch ON
Turn on taps
Open lid, redistribute load
and close lid
Close lid
Open lid, redistribute load,
close lid
Close lid
Check drain hose for blockage
Wait a short while, the wash
will continue
In future, reduce detergent
dose or use low sudsing
(front load) detergent
Turn taps on
Clean tap filters/washers
Raise drain hose or fit a
syphon break
Refer to installation
instructions for correct
positioning of hose
Make the machine level
Adjust feet to touch the floor
Redistribute clothes evenly
Check connections at taps
and rear of machine
Use low water level