Table of Contents
Advertisement
22
Technical data
After the check, switch on the appliance. Set the knob on the same washing programme
as before the malfunction.
The programme continues from the point of interruption. If the malfunction shows again,
contact your Service Force Centre.
If the display shows a fault code, not described in the chart, contact your Service Force
Centre.
These data are necessary to help you quickly and correctly:
• Model (Mod.)
• Product number (PNC)
• Serial number (S.N.)
For these data, refer to the rating plate.
Write the necessary data here:
Model description : ..........
Product number : ..........
Serial number : ..........
The dishes are not clean
Limescales particles on the
dishes
The dishes are wet and dull
There are streaks, milky spots
or a bluish coating on glasses
and dishes
Dry water drop signs on
glasses and dishes
Technical data
Dimensions
Electrical connection - Voltage
- Overall power - Fuse
Water supply pressure
The cleaning results are not satisfactory
• The selected washing programme is not applicable for the type
of load and soil.
• The baskets are loaded incorrectly so that water cannot reach all
surfaces.
• Spray arms do not turn freely because of incorrect arrangement
of the load.
• The filters are dirty or not correctly installed.
• The quantity of detergent is too little or missing.
• The salt container is empty.
• The water softener is adjusted on a wrong level.
• The salt container cap is not closed correctly.
• No rinse aid has been used.
• The rinse aid dispenser is empty.
• Decrease the rinse aid dosage.
• Increase rinse aid dosage.
• The detergent can be the cause.
Width cm
Height cm
Depth cm
Information on the electrical connection is given on the rating
plate on the inner edge of the dishwasher door.
Minimum
Maximum
59,6
81,8 - 87,8
59,5
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
Advertisement
Table of Contents
