Load Sensing - Sensor Logic - AEG FAVORIT 60830 User Instructions

Cancelling the start delay:
As long as the dishwashing cycle has not begun you are able to cancel
the start delay. Continue pressing the delay timer button until the
length of the selected dishwashing cycle appears in the multi-display.
The selected dishwashing cycle will begin immediately.
Changing the dishwashing cycle after the start delay has been set:
As long as the dishwashing cycle has not started, you can still change
the start delay set by pressing a cycle button.
0 1. Press the button for the new dishwashing cycle and hold it down.
First the indicator for the dishwashing cycle that has just been selected
will flash.
After several seconds only the indicator for the new dishwashing cycle
will be flashing.
2. Release the cycle button.
The newly selected dishwashing cycle will start automatically following
a countdown of the hours set.
Load Sensing – Sensor Logic
If a wash programme is started even though there are only a few dishes
in the upper and/or lower rack, an intelligent electronic system adjusts
the amount of water and the duration of the wash programme to the
number of dishes. By this means it is possible to wash only a few dishes
quickly and economically. At half load (6 place settings), up to 2 litres
of water and 0.2 kWh of electricity are saved.
Operating Instructions
33