Honda CBR250R/RA Owner's Manual page 109

Rear Wheel Installation
To install the rear wheel, reverse the
removal procedure.
1.
Install the rear axle shaft, side collars and
rear wheel to the swingarm.
Make sure that the lug ( ) on the brake
caliper bracket ( ) is located in the slot 2
( ) in the swingarm ( ). 3
(2)
(4)
(1) Lug
(2) Brake caliper bracket
1
4
(3)
(1)
(3) Slot
(4) Swingarm
http://mototh.com
2. Install the drive chain over the driven
sprocket.
3. Install the rear axle nut.
4.
Adjust the drive chain (page
5. Tighten the rear axle nut to the specified
torque:
88 N·m (9.0 kgf·m , 65 lbf·ft)
When installing the wheel, carefully fit the
brake disc between the brake pads to avoid
damaging the pads.
After installing the wheel, apply the brake
several times and then check if the wheel
rotates freely. Recheck the wheel if the
brake drags or if the wheel does not rotate
freely.
If a torque wrench is not used for
installation, see your dealer as soon as
possible to verif y proper assembly.
Improper assembly may lead to loss of
braking capacity.
88
).
99