Emergency Numbers; Troubleshooting - iDect X1 User Manual

Color profile: Generic CMYK printer profile
Composite Default screen
Base unit settings
Emergency You can set up to four emergency (SOS) numbers, each
numbers with up to ten digits. These numbers can always be
dialled using any handset, even when call barring is
turned on. Emergency numbers 1 and 2 are preset as
999 and 112.
1 CALL CONTROL
Select the
the â button THREE times
è
The display shows
2 Press the PHONE/OK button
è
The display shows
SOS NUM and
If necessary, use the â or á button to go to
3
the number you want
(For example, you may want to leave numbers
1 and 2 as they are, and set a new emergency
number as number 3.)
4
Press the PHONE/OK button
è
The display shows
example) and any number that is already set.
5 Key in the new emergency number and
press the PHONE/OK button
è
The display goes back to
NUMBER
and you can set another emergency
number if you wish.
42
E:\Binatone2005\iDECT_X1\iDECT_X1_UK_draft02a.vp
25 August 2005 16:47:49
option then press
EMERGENCY NUMBER
EMERGENCY NUMBER
1 , 2 , 3 or 4
ENTER SOS NUM 3 * (for
EMERGENCY

Troubleshooting

The iDECT X1 must be serviced by trained engineers.
!
NEVER attempt any repairs or adjustments yourself
— you could make the problem worse and invalidate
the Guarantee.
ALWAYS check you have followed all the steps listed on pages 5 to 7
first that: to install and set up your iDECT X1
all connectors are firmly inserted in their sockets
mains power is switched on at the socket
the handset's batteries are correctly and securely
installed, and are not run down
Everyday use
"I cannot make If the handset's display is blank, it may be switched off.
Press the HANG UP button to switch it back on.
or answer calls."
Check that the base unit's mains power adapter is
plugged in and power is switched on. The base unit
needs mains power for normal operation of the phone
— not just for charging the batteries.
Make sure you're using the telephone line cable that
was supplied with your iDECT X1. Other telephone line
cables might not work.
Move the handset closer to the base unit.
Check the Battery Level symbol on the display. If it's
low, replace the handset on the base unit or charger
pod to recharge the batteries.
If auto-answer is turned off (page 32), you need to
press any button (except HANG UP) on the handset to
answer an incoming call. Turn auto-answer on if you
want to answer calls by simply lifting the handset from
the base unit or charger pod.
Switch off power at the mains socket, wait for a few
seconds and then switch back on. This may help.
Help Line: 0845 345 9677
(Local Call rate)
43