Making And Answering Calls; Using The Speakerphone; To Make A Call; To Answer A Call - iDect X1 User Manual

Color profile: Generic CMYK printer profile
Composite Default screen

Making and answering calls

Using the The speakerphone lets you hear calls without holding
speakerphone the handset to your ear.
You can switch between speakerphone and earpiece
mode during calls at any time by pressing the
PHONE/SPEAKERPHONE button. The display will show
SPEAKER PHONE ON
or
1

To make a call

Key in the telephone number
If you make a mistake, press the HANG UP
button to clear digits one by one from the display.
2 Press the PHONE button
(You can dial the number after you press the
PHONE button to get Dial tone if you prefer,
but you can't correct any mistakes if you do it
this way. If you press the PHONE button before
you dial, the display shows
To answer a When there's an incoming call, the base unit and handset
call ring (unless the handset's ringer is turned off). If you
subscribe to Caller Display (see page 20) the caller's
number or name may appear on the display; otherwise,
the display shows <<CALL>>
Press any button (except HANG UP) to answer the
call
è
The display shows

To end a call

Press the HANG UP button so that the
IN USE light on the base unit goes out
Or just replace the handset on the base unit
è
The display shows
duration of the call.
14
E:\Binatone2005\iDECT_X1\iDECT_X1_UK_draft02a.vp
25 August 2005 16:47:43
SPEAKER PHONE OFF
ONLINE
.)
.
ONLINE
CALL END
and the
Earpiece During a call, to adjust the volume in the earpiece
volume or speakerphone:
Press the á or â button
There are three volume levels. After you end the
call, the volume will stay at the level you've set.
To mute the During a call, to mute the mouthpiece so the
mouthpiece person on the other end can't hear you:
Press the MENU/MUTE button
To un-mute the mouthpiece, press the
MENU/MUTE button again.
Last Number To make a repeat call to one of the last ten
Redial (LNR) numbers you dialled (up to 32 digits):
1 Press the Redial
Press the á or â button if necessary until
2
the number is displayed
3
Press the PHONE button to dial the number
To edit a 1 Press the Redial
number in the button until the number is displayed
Redial list
2
Press the MENU button
è
The display shows
number ( #01 upwards) and the stored number,
with a flashing cursor
3
Press the HANG UP button to delete digits,
then key in the new digits
4
When you've finished, press the PHONE/OK
button, then the HANG UP button to go
back to standby mode
Help Line: 0845 345 9677
(Local Call rate)
Making and answering calls
button
button, then the á or â
EDIT REDIAL
, the entry
15