Base Unit Settings; To Go Into The Base Setting Menu; Dialling Type And Recall Signal - iDect X1 User Manual

Color profile: Generic CMYK printer profile
Composite Default screen

Base unit settings

BASE SETTING
The menu lets you customise your base
unit to suit your preferences. Some of the functions in
this menu have been covered earlier in this User Guide.
1
To go into Press the MENU button
the Base è
The display shows
Setting
Press the â button THREE times
2
menu
è
The display shows
Press the PHONE/OK button then the â
3
button
è
The display shows
4 Press the PHONE/OK button
If you've set a new PIN for the base unit (page
34), the display will show
and you'll need to key it in. If you've left the PIN
at its default of 0000, you won't be asked for it at
this point.
Press the â button to go to the option you
5
want, then the PHONE/OK button to select
it
All instructions below follow from this step.
When you've finished:
Press the HANG UP button to go back to
standby mode
You can also press the HANG UP button at any point to
cancel what you're doing and go back one step.
When you're keying in numbers, if you make a mistake,
press the HANG UP button to delete digits.
36
E:\Binatone2005\iDECT_X1\iDECT_X1_UK_draft02a.vp
25 August 2005 16:47:48
Ringer volume
and melody
Time & day
Returning to
PHONEBOOK
default
settings
SETTING
BASE SETTING
ENTER BASE PIN *
Dialling type
and recall
signal
Help Line: 0845 345 9677
Base unit settings
ACOUSTIC SETTING
These are set using the
page 13 for details.
See page 10 for details.
The default settings for the base unit are:
3
Ringer volume level —
3
Ringer melody —
Time and day — 00:00 SUN
Dialling mode — TONE
Recall (flash) length — 100MS
0000
Base unit PIN —
Call timer — reset to zero
OFF
Call Barring —
999 112
Emergency numbers — and
To return all base unit settings to their defaults:
DEFAULT SETTING
1 Select the option
è
CONFIRM DEFAULT
The display shows
SETTING?
2 Press the PHONE/OK button to confirm, or
the HANG UP button to cancel
è
The display shows DEFAULT SETTING DONE
The next option in the Base Setting menu is
TONE - 100MS
. This is for setting the dialling type and
the recall (flash) signal length, and you probably won't
ever need this option.
You should always leave the dialling type at its
TONE
default setting — . You should not need to
change the recall signal setting unless you're having
problems using your iDECT X1 on a PBX. Refer to page
46 for more information.
(Local Call rate)
option. See
LINE SET
37