Rear Panel - Repotec RP-WR1134 User Manual

2.1.5 Rear Panel

The rear panel of the router has one Reset button at the left. At the right area are the
Internet and LAN ports and a power connector. Figure 2-2 shows rear panels of these
routers. Table 2-4 explains the function of the port.
Figure 2-2 Rear panel of the Wireless Access Point Router with
Figure 2-5 Front panel of Wireless Access Point Router
Port
Reset
LAN port
Internet port
Uplink port
DC Input Port
Caution: Reset Button
Pressing the Reset button for more than 3 seconds while the router powers up will
restore to factory default setting. Note that this should be done only when you had tried
all the troubleshooting options. Pressing the Reset button during operation may bring
you into the risk of creating IP address conflict between your PC and the router. In such
a case, you may be compelled to reboot your entire system(s).
Caution: Uplink/Normal Switch
If you press down this switch, Port 1 will become the Uplink port. If you press it again,
Port 1 will become a normal LAN port.
Fixed Antenna and one Reverse SMA Antenna
Reset Button Internet & LAN Ports
with Built-in PCMCIA and One Antenna
Table 2-4 All Port Functionality
Pressing the Reset button for more than 3 seconds to
restore to the factory default setting.
This is where you connect to the PC.
This is where you connect to the Cable/DSL modem.
Press the Uplink button and the port will become the uplink
port.
To connect the adapter to receive power.
Wireless Acccess Point Router
Uplink/Normal Switch
Function
11
DC Input Port