Liebert OpenComms Web Card User Manual page 4

INSTALL
Locate the Intellislot bay on the back of your
Liebert PowerSure Interactive, UPStation GXT, or
Nfinity UPS (Use the Intellislot labeled COM1).
Remove the plastic Intellislot cover.
Insert the OpenComms Web Card into the
Intellislot bay.
Secure the card with the previously removed
screws.
Connect Ethernet cable.
DHCP: The card ships with DHCP service enabled. The MAC
address is printed on a sticker affixed to the top of the card.
OR
Static IP: To assign a static IP address, you will need to use the
Service Terminal
CONNECT CABLE
Locate the blue serial configuration cable (null
modem) that shipped with the card.
Connect one end of the configuration cable to the
DB-9 port on the card.
Connect the other end of the configuration cable
to a COM port on your PC.
CONFIGURE CONFIGURE
Using a terminal emulation software package, like HyperTerminal™, Using a terminal emulation software package, like HyperTerminal™,
open a direct connection to the card. open a direct connection to the card.
BAUD RATE: BAUD RATE:
DATA BITS: DATA BITS:
PARITY: PARITY:
STOP BITS: STOP BITS:
FLOW CONTROL: None FLOW CONTROL: None
Press "ENTER" for the Main Menu. Press "ENTER" for the Main Menu.
Select option "2" and follow the instructions to enter an IP Select option "2" and follow the instructions to enter an IP
ADDRESS, NETMASK, and GATEWAY. ADDRESS, NETMASK, and GATEWAY.
Return to the Main Menu and select option "x" to exit and save Return to the Main Menu and select option "x" to exit and save
to configure the card. Proceed to steps 2 & 3.
9600 9600
8 8
None None
1 1