Auto Power Off Function; Using The Tuner - Vox MINI 3 G2 Owner's Manual

Auto Power Off Function

The VOX MINI3 G2 is equipped with an Auto Power Off function. The
Auto Power Off function automatically turns the power off when there
has been no user input for about 1 hour.
When the power is turned off, it's not restored even if a knob or selector
is used. Turn on the power again.
NOTE: The Auto Power Off function will be in effect when signal is input
only to the AUX IN jack or when the input volume to the INPUT
jack and MIC IN jack is too low.
NOTE: The Auto Power Off function is set to on as the factory default.
Setting the Auto Power Off function to enable or disable
1. Press and hold down the TAP button and turn on the
power.
2. The TAP/TUNER LED will indicate the current setting.
3. Press the TAP button to switch between the enable and
disable setting.
4. Wait a few seconds without using any of the buttons or
controls. The unit will automatically switch to normal
operation.
NOTE: The Auto Power Off function enable and disable setting will be
saved even when the power is turned off.
NOTE: If you change a setting for the Auto Power Off function, the time
setting of the delay/reverb effect will be reset to the factory de-
fault.

Using the Tuner

The MINI3 G2's tuner function lets you tune a guitar that's connected
to the INPUT jack. The tuner detects the pitch of the input sound, then
indicates the discrepancy from the standard pitch of E.
1. Press and hold down the TAP button for more than one second.
All effects will be bypassed, and the tuner function will turn on.
2. Play the open 6th string.
NOTE: Be careful not to touch any other strings.
Enable
3. Tune the guitar so that only the center green LED lights up, as shown
on the right.
HINT: The MINI3 G2 recognizes the pitch of E in any octave. This is
useful if you want to tune to harmonics or tune other musical
instruments, such as a bass guitar.
Disable
4. To exit the tuner function, press the TAP button. The effect bypass
will be canceled.
HINT: Once you tune the 6th string
using the tuner function, tune
the other strings in reference
to the 6th string.
All effects are bypassed.
(No valid signal is being input.)
The pitch is sharp.
The pitch is
slightly sharp.
In tune.
The pitch is
slightly flat.
The pitch is flat.
7