Setup; Installing Batteries - Vox MINI 3 G2 Owner's Manual

Setup

This section describes the basic setup of your amplifier.
NOTE: This manual also describes safety precautions and functions. Be
sure to read the entire manual.
1. Set the VOLUME knob and TRIM knob to the minimum level.
2. Install batteries in the amplifier. Alternatively, you can connect the
included AC adapter to the DC12V jack on the rear panel, then plug
the adapter into an AC outlet.
3. Plug your guitar into the INPUT jack on the top panel.
If you also plan to use a CD or MP3 player or a microphone, connect
the player to the AUX IN jack, or the microphone to the MIC IN jack
on the top panel.
4. Press and hold down the power button until the power LED lights up
and the power turns on.
NOTE: When turning off the power, press and hold down the power
button until the power LED turns off.
5. Slowly raise the VOLUME Knob to the desired level.
When using a microphone, you can adjust its volume with the TRIM
Knob.
4

Installing Batteries

Remove the battery compartment cover that's located on the bottom of
the unit by pulling the ribbon. Insert six AA-size alkaline batteries as
shown in the figure.
NOTE: Batteries are not included. You will need to purchase them sepa-
rately. Never use any type of battery other than alkaline batteries.
NOTE: Be sure to install batteries in the correct orientation.
Replacing the Batteries
Replace the batteries when the power LED becomes dim.
NOTE: If the battery level becomes low, noise may be generated.
NOTE: Depleted batteries must be removed from the MINI3 G2 immedi-
ately. If you leave them in, malfunctions such as battery leakage
may occur. You should also remove the batteries if you're not
going to be using the MINI3 G2 for an extended period of time.