Key Positions; Key Positions - Functions At Different Levels - Volvo V70 Owner's Manual

Key positions

The remote control key can be used to set the
vehicle's electrical system in different modes/
levels so that different functions are available;
see Key positions - functions at different lev-
els (p. 69).
Ignition switch with remote control key extrac-
ted/inserted.
NOTE
For cars with the Keyless* function the
remote control key does not need to be
inserted into the ignition switch but can be
stored in e.g. a pocket. For more informa-
tion on Keyless functions, see Keyless
drive* (p. 163).
Insert the remote control key
1. Hold the end of the remote control key
with the detachable key blade and insert
the remote control key in the ignition
switch.
2. Then press the remote control key in the
lock up to its end position.
IMPORTANT
Foreign objects in the ignition switch can
impair the function or destroy the lock.
Do not press in the remote control key
incorrectly turned - hold the end with the
detachable key blade, see Detachable key
blade - detaching/attaching (p. 160).
Remove the remote control key
Push the remote control key, allow it to eject,
then pull it out from the ignition switch.
03 Instruments and controls
Key positions - functions at different
levels
In order to enable the use of a limited number
of functions with the engine switched off, the
car's electrical system can be set in 3 differ-
ent levels (key positions) - 0, I and II - with the
remote control key. Throughout this owner's
manual these levels are described using the
denomination "key positions".
The following table shows the functions avail-
able in each key position/level.
*
Option/accessory, for more information, see Introduction.
03
69