Cleaning And Maintenance - Viking 30”W Use & Care Manual

Cleaning and Maintenance

Cleaning Problems on Glass Ceramic Top
Problem Cause To Prevent
Metal Sliding or scraping DO NOT slide
markings metal cookware metal objects
(silver/gray on glass top. across top.
marks)
Hard water Condensation Make sure the
spots from cooking may bottom of
cause minerals cookware is dry
found in water before cooking.
and acids to drip Daily use of
on to glass top cleaning cream will
and cause gray help keep top free
deposits (the from hard water
spots are often so mineral deposits
thin they appear and food
to be in the glass discoloration.
top).
Pitting or Boil over of sugar Watch sugar and
flaking syrup on glass top. syrups carefully to
This can cause avoid boil overs.
pitting if not
removed
immediately.
18
(cont.)
To Remove
Remove metal
marks before the
glass top is used
again. Apply
cleaning cream
with a damp
paper towel and
scrub with a nylon
scrub pad or
brush. Rinse
thoroughly and
dry.
Mix cleaning
cream with water
and apply a thick
paste to stained
area. Scrub
vigorously. If stain
is not removed,
reapply cleaner
and repeat
process. Also
try cleaning
procedure for
smearing and
streaking.
Turn element to
LO; use several
paper towels to
wipe the spill
immediately. Let
glass top cool and
carefully scrape off
remainder of burn-
off with a single-
edged razor blade
held at a 30° angle.
Cleaning and Maintenance
Cooktop Surfaces
Several different finishes have been used in your cooktop. Cleaning
instructions for each surface are given below. NEVER USE AMMONIA,
STEEL WOOL PADS OR ANY ABRASIVE CLOTHS AND MATERIALS
SUCH AS CLEANSERS, OVEN CLEANERS, OR ABRASIVE POWDERS.
THEY CAN PERMANENTLY DAMAGE YOUR COOKTOP.
Control Panel
DO NOT use any cleaners containing ammonia, abrasives or stainless
steel cleaners on any surface that contains graphics. These products
could remove the graphics from the control panel. Apply hot, soapy
water to a soft clean cloth. DO NOT spray liquids directly onto the
control panel.
Control Knobs
MAKE SURE ALL CONTROL KNOBS POINT TO THE "OFF" POSITION
BEFORE REMOVING. Pull the knobs straight off. Wash in detergent and
warm water. Dry completely and replace by pushing firmly onto stem.
Stainless Steel Parts
All stainless steel body parts should be wiped regularly with hot, soapy
water at the end of each cooling period and with a liquid cleaner
designed for that material when soapy water will not do the job. DO NOT
use steel wool, abrasive cloths, cleansers, or powders. If necessary, scrape
stainless steel to remove encrusted materials, soak the area with hot
towels to loosen the material, then use a wooden or nylon spatula or
scraper. DO NOT use a metal knife, spatula, or any other metal tool to
scrape stainless steel. DO NOT permit citrus or tomato juice to remain on
stainless steel surface, as citric acid will permanently discolor stainless
steel. Wipe up any spills immediately.
19