Helpful Hints - Gemini Gemtek User Manual

Helpful Hints

• For optimum performance, you should keep your Gemtek in the "On"
position at all times, even while charging the battery. It is only required to
charge the battery in the "Off " position the first time.
• Charging light will always be orange when the device is in the "On" position
while charging, even when the battery is fully charged.
• Signal light sequence when device is turned On:
• Signal light stays solid blue up to 1 - 1.5 minutes while device is in start
up mode and searching for a GPS signal.
• Signal light blinks green slowly 4 times to indicate device is registering
with the GSM (cellular) network.
• Device is always searching for a GPS signal. Your device will blink in one of
the following ways indicating normal standby mode, ready to use.
• Signal light will alternately flash green and red, indicating the device
currently has GPS coverage.
• Signal light will alternately flash green and blue, indicating the device has
no current GPS coverage but does have a position stored in memory.
• To test for GPS and/or GSM (cellular) signals while in normal standby mode,
press the "Test" Button.
• Blue light stays on up to 4 seconds if GPS signal is OK (If no GPS signal,
then signal light blinks blue for 20 seconds).
• Green light stays on up to 4 seconds if GSM (cellular) signal is OK (No
green light if no GSM signal).
• Geofence and SOS Buttons must be held for at least 4 seconds, all other
buttons press for 2 seconds.