Load Sensing - Automatic; Switching Off The Dishwasher; Emptying The Dishwasher - Atag VA6011RF User Instructions

Operating Instructions
Changing the wash programme after the start delay has been set:
As long as the wash programme has not yet started, you are able to
change the start delay set by pressing a wash programme button.
1. Press the button for the new wash programme and hold it down.
0
First, the indicator for the wash programme that was already selected
will flash.
After several seconds only the indicator for the new wash programme
will be illuminated.
2. Release the programme button.
The wash programme will start automatically following a countdown
of the hours set.
Load Sensing – AUTOMATIC
If a wash programme is started even though there are only a few dishes
in the upper and/or lower rack, an intelligent electronic system adjusts
the amount of water and the duration of the wash programme to the
number of dishes. By this means it is possible to wash only a few dishes
quickly and economically. At half load (6 place settings), up to 2 litres
of water and 0.2 kWh of electricity are saved.

Switching Off the Dishwasher

Only switch off the dishwasher when
gramme progress display.
1. Press the ON/OFF button.
0
The ON/OFF button indicator extinguishes.
Hot steam may escape from the appliance when opening the door
1
immediately after the end of the programme. Therefore:
2. Open the door carefully.

Emptying the Dishwasher

• Hot dishes are sensitive to knocks. The dishes should therefore be
3
allowed to cool down before removing them from the appliance.
• Leave the dishes in the dishwasher for approx. 15 minutes after the
end of the programme so that they dry better and can cool down.
• First empty the lower rack, and then the upper rack. By using this
procedure you will avoid any water that may be remaining in the
upper rack, dripping onto the dishes in the lower rack and leaving
water marks.
28
L
is illuminated on the pro-