Panasonic PT-EZ770Z Operating Instructions Manual page 118

[Network config] page
Click [Detailed set up] → [Network config].
f Click [Network config] to display the [CAUTION!] screen.
f Click the [Next] button to display the current settings.
f Click the [Change] button to display the setting change screen.
1 [PROJECTOR NAME]
Enter the name of the projector. Enter the host name if it is
required when using a DHCP server etc.
2 [DHCP ON], [DHCP OFF]
To enable the DHCP client function, set to [DHCP ON].
3 [IP ADDRESS]
Enter the IP address when not using a DHCP server.
4 [SUBNET MASK]
Enter the subnet mask when not using a DHCP server.
5 [DEFAULT GATEWAY]
Enter the default gateway address when not using a DHCP
server.
Note
f When you use the "Forward" and "Back" functions of your browser, a warning message "Page has Expired" may appear. In that case, click
[Network config] again since the following operation will not be guaranteed.
f Changing LAN settings while connected to the LAN may cause the connection to cut out.
[Ping test] page
Check whether the network is connected to the E-mail server, POP server, DNS server, etc.
Click [Detailed set up] → [Ping test].
1 [Input IP address]
Enter the IP address of the server to be tested.
2 [Submit]
Executes the connection test.
118 - ENGLISH
Chapter 4 Settings — [NETWORK] menu
1
2
1
2
3
4
5
6
7
8
6 [DNS1]
Enter the DNS1 server address.
Permissible characters for the entry of DNS1 server address
(primary):
Numbers (0 - 9), period (.)
(Example: 192.168.0.253)
7 [DNS2]
Enter the DNS2 server address.
Available characters for the entry of DNS2 server address
(secondary):
Numbers (0 - 9), period (.)
(Example: 192.168.0.254)
8 [Back], [Change]
Click the [Back] button to return to the original screen. The
screen for confirming the current settings is displayed by
clicking the [Change] button. Click the [Submit] button to update
the settings.
3 Example of display when the connection has succeeded
4 Example of display when the connection has failed
3
4