Initial Operation; Setting Up The Device; Connect Power Supply; Installing Or Changing The Batteries Of The Remote Control - Philips Screeneo HDP1550 User Manual

3 Initial Operation

Setting up the Device

Before installing your device, make sure that the
projector is turned off and the power cord is
unplugged from the power outlet.
You can position the device so that it lies flat on a table
in front of the projection surface; it is not necessary to
tilt it towards the projection surface. The device com-
pensates for the distortion from the slanted projection
(pincushion distortion).
Check that the projection surface is appropriated to the
projector. The distance between the projector and the
screen determines the actual size of the image.
To change the size of the screen, just move the projec-
tor towards or away from the wall.
The size of the screen (b) is comprised between 50 and
100 inches depending on the projection distance (a), as
described in the following table.
Diagonal size (b)
(mm)
[inch]
1270
[50]
2540
[100]

Connect Power Supply

CAUTION!
The power cord is used as a power unit cut
off. As a precaution, the outlet shall be located
close to the device and be of easy access in
case of danger.
10
Projection distance
(a)
(mm)
108
441
1 Connect the power cord into the socket on the rear
side of your device (1).
2 Plug the power cord to outlet on the wall (2).

Installing or Changing the
Batteries of the Remote
Control
DANGER!
Risk of Explosion with Incorrect Type of
Batteries
Only use the AAA type battery.
There is a risk of explosion if the incor-
rect battery type is used.
1 To access the battery, press to unlock the locking
mechanism (1) and slide out the battery compart-
ment (2).
2 Insert the new batteries into the battery compart-
ment with the positive and negative poles as shown.
Make sure the polarities(+ and -) are aligned cor-
rectly.
Philips · HDP15x0 & HDP15x0TV