Before Calling For Service - Amana Commercial Combination Oven Owner's Manual

Before Calling for Service

To avoid electrical shock which can cause severe personal injury or death, do not remove outer case at any time.
Only an authorized servicer should remove outer case.
Problem
Oven does not operate.
Oven operates intermittently or
HOT
shows in display.
If oven does not accept entries
when pad is pressed.
If oven malfunctions or shows:
Error2
(example)
Oven fan turns on while oven is
not preheating or cooking.
Part No. 13092901
Printed in U.S.A. 6/07
!
WARNING
Possible Cause
Confirm oven is plugged into dedicated circuit.
Confirm oven is on grounded circuit.
(Contact electrician to confirm)
Check fuse or circuit breaker.
Check air filter and discharge areas for obstructions.
Make sure oven is on and preheated.
Open and close oven door. Press pad again.
Oven control is equipped with a self-diagnostic system. Self-diagnostic
system alerts you if there is an error or problem. When electronic control
signals a problem, follow steps listed below.
1. Record number shown. (example of Error2 shown)
2. Unplug oven, wait for 1 minute, and plug in oven.
• Disconnecting electrical supply may eliminate service code. If failure
continues, contact an authorized servicer.
Normal operation.
F
or full product documentation visit:
www.amanacommercial.com
14
© 2007 AGA Commercial Products
Amana, Iowa 52204