Configuring Vcs - LevelOne WBR-3600 User Manual

Configuring VCs

The WBR-3600 Router supports multiple VCs (Virtual Circuits) on the ADSL
connection.
VC1 must be used for general-purpose Internet access. The other VCs are available
for special purposes, such as Video-on-Demand.
You can only use these VCs if supported by your ISP and ADSL service provider. In
that case, they will provide the necessary configuration data.
Some ISP's allow multiple PPPoE connections. This allows multiple
PCs to connect to the Internet using PPPoE client software. When
using the WBR-3600 Router, multiple PPPoE connections are
neither necessary nor supported.
To Configure additional VCs
1. Start the Setup Wizard again.
2. On the first screen, select VC2, and click "Next"
3. Configure the VC setup screen as described below, then click "Next".
Setup Wizard VC Screen
VC
Enable
VPI
VCI
Multiplexing
Figure 8: Setup Wizard - VC2
The VC number is displayed
To use this VC, you must enable it by checking this checkbox.
Enter the VPI value provided by your ISP.
Enter the VPI value provided by your ISP.
Select the multiplexing value provided by your ISP.
16