Chrysler 200 Sedan 2012 Owner's Manual page 203

the conventional brake system will continue to operate
normally provided that the BRAKE warning light is not
on.
If the ABS light is on, the brake system should be serviced
as soon as possible to restore the benefit of Anti-Lock
Brakes.
The ABS warning light should be checked frequently to
assure that it is operating properly. Turn the ignition key
to the on position, but do not start the vehicle. The light
should come on. If the light does not come on, have the
system inspected by an authorized dealer.
24. Electronic Stability Control (ESC) Activation/
Malfunction Indicator Light — If Equipped
The "ESC Activation/Malfunction Indicator
Light" in the instrument cluster will come on
when the ignition switch is turned to the
ON/RUN position. It should go out with the
UNDERSTANDING YOUR INSTRUMENT PANEL 201
engine running. If the "ESC Activation/Malfunction In-
dicator Light" comes on continuously with the engine
running, a malfunction has been detected in the ESC
system. If this light remains on after several ignition
cycles, and the vehicle has been driven several miles
(kilometers) at speeds greater than 30 mph (48 km/h), see
your authorized dealer as soon as possible to have the
problem diagnosed and corrected.
NOTE:
• The "ESC Off Indicator Light" and the "ESC
Activation/Malfunction Indicator Light" come on mo-
mentarily each time the ignition switch is turned to
ON/RUN.
• Each time the ignition is turned to ON/RUN, the ESC
system will be ON, even if it was turned off previously.
4