Wireless Client Bridge-To-Central Wireless Bridge - Advantech EKI-6311G User Manual

Ieee 802.11 b/g wireless access point/client bridge

Table of Contents

3.1

Wireless Client Bridge-to-Central Wireless Bridge

Figure 3-2

Refer to Figure 3-2 for the following setup.

Note: The EKI-6311G AP is the Central Wireless Bridge and EKI-6311G CB is the

Wireless Client Bridge

Step 1 Set the EKI-6311G AP to perform a bridge (bridge IP address:

192.168.1.1).

Step 2 Set Wireless parameters on the AP to: Channel (1) and SSID

(wireless)

Step 3 Set the EKI-6311G CB to function in the bridge mode (bridge IP address:

192.168.1.241).

Step 4 Set Wireless parameters on the EKI-6311G CB to: Channel (1) and

SSID (wireless), and these parameters must be the same with COU.

Step 5 Left side subnet is transparent to the right side.

Step 6 DHCP server assign IP address to PC1 and PC2

Table of Contents