Master/Slave & Stand Alone; Built In Programs Detailed - Chauvet COLORstrip User Manual

Master/Slave & Stand Alone
The Master/Slave mode will allow you to link units in a daisy chain fashion. In this mode, the first unit
in the daisy chain will command all other units following. Stand Alone can simply be achieved by
setting all units to Master. They would no longer be required to be linked in series.
MASTER UNIT Settings
Press the Mode button repeatedly
until the display reads [Act] then
press the Enter button.
Select programs 001 ~ 023 by using the
Up and Down buttons.
Some programs have additional
controls such as flash and run
speed. Press the Mode button
to toggle additional functions,
then use the Up and Down
buttons to change values.
Refer to the Control Panel
Modes & Functions chart on
the previous page.
SLAVE UNIT Settings
Units that follow the Master unit
will automatically synchronize to
the Master unit. No other
settings are required.
IMPORTANT INSTRUCTIONS FOR MASTER/SLAVE OPERATION
Turn ON the Master unit last! This will assure that the master unit will fully detect all linked units and re-configure its
built-in sequential chase programs to run on the correct number of linked units.

Built in programs detailed

P
ROGRAM
000
001-007
008-013
014-020
021
022
COLORstrip™ User Manual
F
UNCTION
Blackout
Solid flashing colors
Color chase programs
Sequential color chase patterns
RGB (manual color mix)
Color fade
11
Master
Slave
DMX signal output
does not continue
on M/S linked
fixtures.
Slave
Slave
O
PTIONS
F = Flash speed
P = Run speed
F = Flash speed
Use sound sensitivity rotary knob to adjust sound
level for optimum response or decrease sensitivity
completely to operate in Run speed only
P = Run speed
P = Red
F = Green
C = Blue
P = Run speed
Master/Slave Link
output
3 Pin XLR DMX cable
2010-01-26/14:45