Sd Card Playback; Basic Operation During Playback From An Sd Card - LENCO SCD-2000 BT User Manual

SD card playback

Through the built-in SD card slot (9) MP3 and WMA files can be played. Enter the SD
mode by pressing the source button (3, 29) until CARD is shown on the display (14).
Open the USB / SD cover by sliding it towards the handle (1) as can be seen in the
figure below.
Insert the SD card, when it is connected properly, the radio will start reading the
device. Once the SD card is read, the radio will automatically start playback.

Basic Operation during playback from an SD card

Pause playback,
playback. Press the play / pause button (15, 25) again to resume playback.
Stop playback, press the stop button (16, 33) during playback to stop playback.
Skip to next track,
track.
Skip 10 tracks, it is possible to skip 10 tracks at once. This can be done by pressing
the folder button (5, 26).
Fast Foward, hold the next button (11, 34) during playback to fast forward. Once the
button is released, the device will stop fast forwarding.
Skip to previous track,
the previous track.
Rewind, hold the previous button (11, 34) during playback to rewind. Once the button
is released, the device will stop rewinding.
Using the repeat function,
folder or all tracks on the media will be repeated. Press the play mode button (4, 36)
to enable the repeat function. The repeat mode can be changed or disabled by
repeatedly pressing the play mode button (4, 36). The display (14) will show the
active repeat mode as follows:
 REP 1: Current track is repeated.
 REP FOLDER: Current folder is repeated (Only for media with with multiple
folders).
 REP ALL: All tracks on media are repeated.
press the play / pause button (15, 25) during playback to pause
press the next button (11, 34) during playback to skip to the next
press the previous button (11, 34) during playback to skip to
when the repeat function is enabled, the current track, a
17